Product Description:
TremGlaze SA1100 is a paintable pure acrylic latex sealant formulated to provide a fast-setting pliable seal
with minimal shrinkage.
Basic Uses:
TremGlaze SA1100 can be used for general purpose interior and exterior caulking where movement
does not exceed 12.5%. Ideal for window frame perimeters.
Limitations:
Do not apply to damp or contaminated surfaces.                                                                                                                                                                                                                                  Color:
Clear                                                                                                                                                                                                                                                                                         INSTALLATION
Joint Design:
May be used in any vertical or horizontal joint design in accordance with accepted architectural/engineering
practice. Movement should not exceed 12.5% of the minimum joint width.
Joint Dimensions:
For joints 1/4 inch (6.4 mm) to 1/2 inch (12.7 mm) wide, the width to depth ratio should be equal. Joints 1/2 inch (12.7mm) wide or
greater should have a depth of 1/2 inch (12.7 mm). Minimum joint size is 1/4 inch by 1/4 inch (6.4 mm by 6.4 mm).
Surface Preparation:
For good adhesion, the joint interface must be sound, clean and dry. Depending on the substrate, or presence of form release agents, dust, masonry
waterproofings, loose mortar or laitance, architectural paints or finishes, the joint surface may require a thorough wire brushing, grinding, sandblasting and
solvent washing.
Tooling & Cleaning
Tooling is recommended immediately after application to insure firm, intimate contact with the joint interface. Dry tooling is
preferred. Cleaning can be accomplished with soapy water while sealant is in uncured state.
Joint Backing, Bond Breaking Tape:
Closed cell polyethlyene backer rods are preferred as joint backing to control depth of sealant bead. Where depth of joint will prevent
use of joint backing, an adhesive backed polyethylene tape should be installed to prevent three side adhesion. Joint backing must bedry at time of sealant application

Not sure which sealant to choose? try looking at our help page "which sealant should I use?"